P0135 on Honda: Symptoms, Causes & DIY Fix
Official technical diagnostic wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically affecting Honda vehicles (Civic, Accord, CR-V, Pilot, HR-V, Odyssey, Ridgeline, Passport).
1. Symptoms of P0135 on Honda
When the Engine Control Module (ECM/PCM) on your Honda logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Honda
Historical warranty claims and technical repair bulletins for Honda point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Honda
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on Honda vehicles (Civic, Accord).
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on Honda vehicles (Civic, Accord).
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on Honda vehicles (Civic, Accord).
4. Honda P0135 FAQs
What causes code P0135 to trigger on a Honda?
On Honda vehicles, P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse. Factory sensor degradation or wiring harness wear near the engine bay are common factors.
Can I safely drive my Honda with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating on Honda vehicles, we advise performing diagnostic scanning via the OBD-II port before extended driving.
How much does it cost to fix P0135 on a Honda?
DIY replacement parts typically range between $80 - $240 (DIY Sensor: $45). If serviced at an authorized Honda dealership, expect an additional $120–$250 in professional labor based on their $115/hr hourly rate.