FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0442

Buick Enclave Hub All Buick P0442Low Severity

P0442 on Buick Enclave: Fix & DLC Location

Factory diagnostic troubleshooting wire for fault code P0442 (EVAP System Small Leak Detected - Diagnosis & Repair Guide) specifically on the Buick Enclave (2020–2026, 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)).

2020–2026

EnclaveSUV

Sensor Voltage Ref

0.1V – 5.0V Ref

Enclave SAE Mode $01

ECU Network Bus

500 kbps CAN-FD

ISO 15765-4 Compliant

Drivability Status

Drivable (Short Trip)

Low urgency level

Est. DIY Time

45 – 90 Min

Basic hand tools

Check P0442 On Another Buick Model:

Buick Enclave

1. Symptoms of P0442 on Buick Enclave

When the Engine Control Module (ECM/PCM) on your Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)) logs fault code P0442, drivers commonly observe:

Check Engine Light on on Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP))

Intermittent faint fuel odor near rear wheel well on Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP))

Failed OBD-II smog check on Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP))

Buick Enclave OBD-II Port Location

The 16-pin diagnostic connector is located Driver lower knee bolster panel. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Buick Enclave

Historical warranty claims and technical repair bulletins for Buick Enclave point to the following failure distribution:

55%

Worn or cracked gas cap rubber seal (Buick OEM Part)

25%

Small split in charcoal canister vapor line (Buick OEM Part)

12%

Leaking EVAP vent valve solenoid (Buick OEM Part)

3. Step-by-Step DIY Repair Guide for Buick Enclave

Clean or Replace Gas Cap O-Ring

Inspect the gas cap gasket for micro-cracks or debris. Replace with OEM cap if hardened. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).

Perform EVAP Smoke Machine Test

Inject mineral oil smoke into the EVAP service port to visually pinpoint the pinhole leak. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).

Replace Vent Solenoid Valve

If smoke escapes from the canister vent, replace the stuck solenoid. on the Buick Enclave equipped with 3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP).

Other Common Fault Codes on Buick Enclave

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Buick Enclave:

P0300Automotive

P0300: Random or Multiple Cylinder Misfi...

View Enclave Fix

P0420Automotive

P0420: Catalyst System Efficiency Below ...

View Enclave Fix

P0171Automotive

P0171: System Too Lean (Bank 1)...

View Enclave Fix

P0128Automotive

P0128: Coolant Temperature Below Thermos...

View Enclave Fix

P0455Automotive

P0455: Evaporative Emission Control Syst...

View Enclave Fix

P0101Automotive

Mass Air Flow (MAF) Sensor Circuit Range...

View Enclave Fix

4. Buick Enclave P0442 FAQs

What causes code P0442 to trigger on a Buick Enclave?

On the Buick Enclave (3.6L V6 (310HP) / 2.5L Turbo 4-Cyl (328HP)), P0442 is most frequently caused by Worn or cracked gas cap rubber seal or Small split in charcoal canister vapor line.

Where is the OBD-II port located on my Buick Enclave?

On the Buick Enclave, the 16-pin DLC diagnostic connector is located Driver lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Buick Enclave with code P0442?

Safe to drive. Will not damage engine internals. Given that P0442 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.