U0142 on Chevrolet Silverado
Factory diagnostic protocol and troubleshooting wire for fault code U0142 specifically for the Chevrolet Silverado (2020–2026, 5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel).
1. Symptoms of U0142 on Chevrolet Silverado
When the Engine Control Module (ECM/PCM) on your Chevrolet Silverado (5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel) logs fault code U0142, drivers commonly observe:
2. Most Likely Causes on Chevrolet Silverado
Historical warranty claims and technical repair bulletins for Chevrolet Silverado point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chevrolet Silverado
Connect an OBD-II scan tool and record freeze frame sensor telemetry for code U0142 to note engine RPM, load, and voltage when the fault triggered. on the Chevrolet Silverado equipped with 5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel.
Inspect the electrical connector and wiring harness related to U0142 for chafing, corrosion, moisture, or pin push-out. on the Chevrolet Silverado equipped with 5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel.
Measure circuit voltage supply (12V B+ or 5V reference) and sensor/actuator resistance according to factory repair manual specifications. on the Chevrolet Silverado equipped with 5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel.
Install a new OEM-grade replacement part, torque fasteners to factory spec, and ensure electrical locking tabs click firmly. on the Chevrolet Silverado equipped with 5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel.
Clear all stored DTCs from vehicle memory and perform an OBD-II drive cycle to confirm the diagnostic monitor resets to 'Ready'. on the Chevrolet Silverado equipped with 5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel.
Equipment for Diagnosing Chevrolet Silverado (U0142)
Chevrolet Silverado OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Chevrolet Silverado.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Chevrolet Silverado
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chevrolet Silverado:
4. Chevrolet Silverado U0142 FAQs
What causes code U0142 to trigger on a Chevrolet Silverado?
On the Chevrolet Silverado (5.3L / 6.2L EcoTec3 V8 & 2.7L Turbo / 3.0L Duramax Diesel), U0142 is most frequently caused by CAN bus communication break or Blown BCM fuse.
Where is the OBD-II port located on my Chevrolet Silverado?
On the Chevrolet Silverado, the 16-pin DLC diagnostic connector is located Under driver dashboard, left of steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chevrolet Silverado with code U0142?
Yes. Secondary body electronics offline. Given that U0142 carries a Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.