P0353 on Chrysler Pacifica Hybrid
Factory diagnostic protocol and troubleshooting wire for fault code P0353 specifically for the Chrysler Pacifica Hybrid (2020–2026, 3.6L Atkinson-Cycle V6 + Dual Electric Motors (260 HP PHEV / 32-Mile EV)).
1. Symptoms of P0353 on Chrysler Pacifica Hybrid
When the Engine Control Module (ECM/PCM) on your Chrysler Pacifica Hybrid (3.6L Atkinson-Cycle V6 + Dual Electric Motors (260 HP PHEV / 32-Mile EV)) logs fault code P0353, drivers commonly observe:
2. Most Likely Causes on Chrysler Pacifica Hybrid
Historical warranty claims and technical repair bulletins for Chrysler Pacifica Hybrid point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Chrysler Pacifica Hybrid
Confirm fault follows the coil. on the Chrysler Pacifica Hybrid equipped with 3.6L Atkinson-Cycle V6 + Dual Electric Motors (260 HP PHEV / 32-Mile EV).
Install new ignition coil and inspect spark plug. on the Chrysler Pacifica Hybrid equipped with 3.6L Atkinson-Cycle V6 + Dual Electric Motors (260 HP PHEV / 32-Mile EV).
Clear trouble codes and road test. on the Chrysler Pacifica Hybrid equipped with 3.6L Atkinson-Cycle V6 + Dual Electric Motors (260 HP PHEV / 32-Mile EV).
Equipment for Diagnosing Chrysler Pacifica Hybrid (P0353)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Chrysler Pacifica Hybrid.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Chrysler Pacifica Hybrid
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Chrysler Pacifica Hybrid:
4. Chrysler Pacifica Hybrid P0353 FAQs
What causes code P0353 to trigger on a Chrysler Pacifica Hybrid?
On the Chrysler Pacifica Hybrid (3.6L Atkinson-Cycle V6 + Dual Electric Motors (260 HP PHEV / 32-Mile EV)), P0353 is most frequently caused by Cylinder 3 ignition coil internal short/open or Harness wiring fault.
Where is the OBD-II port located on my Chrysler Pacifica Hybrid?
On the Chrysler Pacifica Hybrid, the 16-pin DLC diagnostic connector is located Under driver side dashboard above foot pedal assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Chrysler Pacifica Hybrid with code P0353?
No. Cylinder 3 ignition coil has failed. Given that P0353 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.