P0351 on Dodge Challenger
Factory diagnostic protocol and troubleshooting wire for fault code P0351 specifically for the Dodge Challenger (2020–2026, 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP)).
1. Symptoms of P0351 on Dodge Challenger
When the Engine Control Module (ECM/PCM) on your Dodge Challenger (3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP)) logs fault code P0351, drivers commonly observe:
2. Most Likely Causes on Dodge Challenger
Historical warranty claims and technical repair bulletins for Dodge Challenger point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Dodge Challenger
Identify Cylinder 1 ignition coil pack mounted on the valve cover. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Swap Coil 1 with Coil 2. Clear codes and restart engine. If code switches to P0352 (Coil B), the ignition coil is 100% defective. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Check for 12V battery power, chassis ground, and 5V trigger pulse from the PCM on the 3-pin / 4-pin harness plug. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Install a new OEM ignition coil (e.g. Denso, Motorcraft, Delphi) and replace the spark plug on Cylinder 1. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Clear DTCs and verify smooth acceleration under load. on the Dodge Challenger equipped with 3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP).
Equipment for Diagnosing Dodge Challenger (P0351)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Dodge Challenger.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Dodge Challenger
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Challenger:
4. Dodge Challenger P0351 FAQs
What causes code P0351 to trigger on a Dodge Challenger?
On the Dodge Challenger (3.6L Pentastar V6 (305HP) / 5.7L HEMI V8 / 6.2L Redeye Widebody (807HP)), P0351 is most frequently caused by Failed ignition coil pack on Cylinder 1 (Coil A) or Broken or melted wiring harness to ignition coil 1.
Where is the OBD-II port located on my Dodge Challenger?
On the Dodge Challenger, the 16-pin DLC diagnostic connector is located Under driver dash left of center stack. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Dodge Challenger with code P0351?
No. Cylinder 1 ignition coil has failed completely, causing an active misfire and dumping unburned fuel into the catalytic converter. Given that P0351 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.