MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
U0073DodgeDodge Hornet HubAll Dodge U0073Critical Severity

U0073 on Dodge Hornet

Control Module Communication Bus A Off

Factory diagnostic protocol and troubleshooting wire for fault code U0073 specifically for the Dodge Hornet (2023–2026, 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)).

Verified OEM Telemetry & Field Repair Tree
Dodge Hornet2023–2026
Dodge Hornet
SUV2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Hornet SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Not Recommended
Critical urgency level
Est. Repair Cost
$150 - $850 (DIY: $40 - $200)
Parts & Labor DIY
Check U0073 On Another Dodge Model:
Diagnose U0073 on Specific Hornet Model Year:

1. Symptoms of U0073 on Dodge Hornet

When the Engine Control Module (ECM/PCM) on your Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)) logs fault code U0073, drivers commonly observe:

StabiliTrak / Traction / ABS / Engine warning lights lit on Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD))
Transmission shifting harshly or refusing to shift out of 2nd gear on Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD))
No communication with TCM, ABS, or BCM on Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD))
Engine may refuse to crank on Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD))
Dodge Hornet OBD-II Port Location
The 16-pin diagnostic connector is located Under driver steering column lower trim. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Dodge Hornet

Historical warranty claims and technical repair bulletins for Dodge Hornet point to the following failure distribution:

55%
Loose or corroded ground connection on transmission or frame (Dodge OEM Part)
25%
Faulty Transmission Control Module (TCM) or ABS module pulling bus down (Dodge OEM Part)
12%
Poor connection at large body-to-chassis pass-through harness connector (Dodge OEM Part)
8%
Aftermarket accessory (remote starter, GPS tracker, cheap OBD scanner) broadcasting invalid data (Dodge OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Dodge Hornet.

3. Step-by-Step DIY Repair Guide for Dodge Hornet

01
Unplug All Aftermarket OBD-II Devices

Remove any aftermarket insurance dongles, GPS trackers, or scan tools plugged into the DLC port. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).

Required Tool: None
02
Inspect Frame and Transmission Ground Straps

Inspect braided ground straps on engine and transmission. Clean all contact surfaces to bare metal. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).

Required Tool: Wire Brush, Sockets
03
Perform Full Vehicle Network Topology Scan

Scan all modules on vehicle. Note which modules are online and which are offline to pinpoint the break in the network daisy-chain. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).

Required Tool: Full-System OBD-II Diagnostic Scanner
04
Check Terminating Resistance (60 Ohms)

Verify 60 ohms across Pins 6 and 14 with battery disconnected. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).

Required Tool: Multimeter
05
Clear All System DTCs & Road Test

Clear DTCs from all modules and road test to verify error-free network transmission. on the Dodge Hornet equipped with 2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD).

Required Tool: Scan Tool
Recommended Parts & Testing Tools

Equipment for Diagnosing Dodge Hornet (U0073)

Prime Fast Delivery & Verified Fitment
Direct-Fit Replacement Part

Dodge Hornet OEM Replacement Sensor

4.7 / 5.0 (Verified Fit)

Direct-fit replacement assembly engineered to OEM tolerances for Dodge Hornet.

$45 – $95 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Dodge HornetVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Dodge Hornet

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Hornet:

4. Dodge Hornet U0073 FAQs

What causes code U0073 to trigger on a Dodge Hornet?

On the Dodge Hornet (2.0L Turbo (265HP) / R/T PHEV (288HP / eAWD)), U0073 is most frequently caused by Loose or corroded ground connection on transmission or frame or Faulty Transmission Control Module (TCM) or ABS module pulling bus down.

Where is the OBD-II port located on my Dodge Hornet?

On the Dodge Hornet, the 16-pin DLC diagnostic connector is located Under driver steering column lower trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Dodge Hornet with code U0073?

No. Bus is shut down due to excessive transmission errors, leaving vehicle in unpredictable limp mode. Given that U0073 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.