P0135 on Ford F-250 Super Duty: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically on the Ford F-250 Super Duty (2020–2026, 6.7L Power Stroke V8 Turbo Diesel (500HP / 1,200 lb-ft) / 7.3L Godzilla V8).
1. Symptoms of P0135 on Ford F-250 Super Duty
When the Engine Control Module (ECM/PCM) on your Ford F-250 Super Duty (6.7L Power Stroke V8 Turbo Diesel (500HP / 1,200 lb-ft) / 7.3L Godzilla V8) logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Ford F-250 Super Duty
Historical warranty claims and technical repair bulletins for Ford F-250 Super Duty point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Ford F-250 Super Duty
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on the Ford F-250 Super Duty equipped with 6.7L Power Stroke V8 Turbo Diesel (500HP / 1,200 lb-ft) / 7.3L Godzilla V8.
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on the Ford F-250 Super Duty equipped with 6.7L Power Stroke V8 Turbo Diesel (500HP / 1,200 lb-ft) / 7.3L Godzilla V8.
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on the Ford F-250 Super Duty equipped with 6.7L Power Stroke V8 Turbo Diesel (500HP / 1,200 lb-ft) / 7.3L Godzilla V8.
Other Common Fault Codes on Ford F-250 Super Duty
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Ford F-250 Super Duty:
4. Ford F-250 Super Duty P0135 FAQs
What causes code P0135 to trigger on a Ford F-250 Super Duty?
On the Ford F-250 Super Duty (6.7L Power Stroke V8 Turbo Diesel (500HP / 1,200 lb-ft) / 7.3L Godzilla V8), P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse.
Where is the OBD-II port located on my Ford F-250 Super Duty?
On the Ford F-250 Super Duty, the 16-pin DLC diagnostic connector is located Driver lower kick panel near emergency brake pedal. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Ford F-250 Super Duty with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.