B0091 on Honda HR-V
Factory diagnostic protocol and troubleshooting wire for fault code B0091 specifically for the Honda HR-V (2023–2026, 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD)).
1. Symptoms of B0091 on Honda HR-V
When the Engine Control Module (ECM/PCM) on your Honda HR-V (2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD)) logs fault code B0091, drivers commonly observe:
2. Most Likely Causes on Honda HR-V
Historical warranty claims and technical repair bulletins for Honda HR-V point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Honda HR-V
Disconnect battery negative cable and wait 15 minutes to fully discharge SRS backup capacitors before touching airbag components. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Remove driver side door sill trim / lower B-pillar trim to access the yellow impact sensor. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Inspect sensor for water corrosion or cracked plastic housing. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Bolt new OEM side impact sensor into clean, rust-free ground location, torque bolt to spec, and click yellow locking connector firmly. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Reconnect battery, clear SRS trouble codes with an airbag-capable scanner, and verify light turns off after 5-second bulb check. on the Honda HR-V equipped with 2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD).
Equipment for Diagnosing Honda HR-V (B0091)
Honda HR-V OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Honda HR-V.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Honda HR-V
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Honda HR-V:
4. Honda HR-V B0091 FAQs
What causes code B0091 to trigger on a Honda HR-V?
On the Honda HR-V (2.0L DOHC i-VTEC 4-Cyl (158HP / CVT AWD)), B0091 is most frequently caused by Corroded or damaged left side impact crash sensor (B-pillar or door sill) or Corroded wiring harness under driver seat / driver door sill.
Where is the OBD-II port located on my Honda HR-V?
On the Honda HR-V, the 16-pin DLC diagnostic connector is located Driver footwell lower trim near kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Honda HR-V with code B0091?
Caution. Side curtain and seat airbag deployment may be disabled in a side-impact collision. Given that B0091 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.