B0091 on Honda Passport
Factory diagnostic protocol and troubleshooting wire for fault code B0091 specifically for the Honda Passport (2020–2026, 3.5L i-VTEC V6 (280HP / AWD TrailSport)).
1. Symptoms of B0091 on Honda Passport
When the Engine Control Module (ECM/PCM) on your Honda Passport (3.5L i-VTEC V6 (280HP / AWD TrailSport)) logs fault code B0091, drivers commonly observe:
2. Most Likely Causes on Honda Passport
Historical warranty claims and technical repair bulletins for Honda Passport point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Honda Passport
Disconnect battery negative cable and wait 15 minutes to fully discharge SRS backup capacitors before touching airbag components. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Remove driver side door sill trim / lower B-pillar trim to access the yellow impact sensor. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Inspect sensor for water corrosion or cracked plastic housing. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Bolt new OEM side impact sensor into clean, rust-free ground location, torque bolt to spec, and click yellow locking connector firmly. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Reconnect battery, clear SRS trouble codes with an airbag-capable scanner, and verify light turns off after 5-second bulb check. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Equipment for Diagnosing Honda Passport (B0091)
Honda Passport OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Honda Passport.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Honda Passport
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Honda Passport:
4. Honda Passport B0091 FAQs
What causes code B0091 to trigger on a Honda Passport?
On the Honda Passport (3.5L i-VTEC V6 (280HP / AWD TrailSport)), B0091 is most frequently caused by Corroded or damaged left side impact crash sensor (B-pillar or door sill) or Corroded wiring harness under driver seat / driver door sill.
Where is the OBD-II port located on my Honda Passport?
On the Honda Passport, the 16-pin DLC diagnostic connector is located Lower driver steering column trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Honda Passport with code B0091?
Caution. Side curtain and seat airbag deployment may be disabled in a side-impact collision. Given that B0091 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.