P0140 on Honda Passport
Factory diagnostic protocol and troubleshooting wire for fault code P0140 specifically for the Honda Passport (2020–2026, 3.5L i-VTEC V6 (280HP / AWD TrailSport)).
1. Symptoms of P0140 on Honda Passport
When the Engine Control Module (ECM/PCM) on your Honda Passport (3.5L i-VTEC V6 (280HP / AWD TrailSport)) logs fault code P0140, drivers commonly observe:
2. Most Likely Causes on Honda Passport
Historical warranty claims and technical repair bulletins for Honda Passport point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Honda Passport
Inspect harness connector under vehicle floor pan. Verify plug is firmly seated and weather seal is intact. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Check for 12V heater power and ground at connector with ignition ON. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Remove and replace the downstream oxygen sensor with an OEM-spec part. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Clear code and verify sensor activity returns on live telemetry. on the Honda Passport equipped with 3.5L i-VTEC V6 (280HP / AWD TrailSport).
Equipment for Diagnosing Honda Passport (P0140)
Honda Passport OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Honda Passport.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Honda Passport
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Honda Passport:
4. Honda Passport P0140 FAQs
What causes code P0140 to trigger on a Honda Passport?
On the Honda Passport (3.5L i-VTEC V6 (280HP / AWD TrailSport)), P0140 is most frequently caused by Completely dead downstream O2 sensor or Disconnected sensor harness plug under car.
Where is the OBD-II port located on my Honda Passport?
On the Honda Passport, the 16-pin DLC diagnostic connector is located Lower driver steering column trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Honda Passport with code P0140?
Yes, safe for normal driving without risk of breakdown. Given that P0140 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.