P0202 on Honda Pilot
Factory diagnostic protocol and troubleshooting wire for fault code P0202 specifically for the Honda Pilot (2021–2026, 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto)).
1. Symptoms of P0202 on Honda Pilot
When the Engine Control Module (ECM/PCM) on your Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto)) logs fault code P0202, drivers commonly observe:
2. Most Likely Causes on Honda Pilot
Historical warranty claims and technical repair bulletins for Honda Pilot point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Honda Pilot
Measure resistance across injector 2 terminals. Compare to Cylinder 1 and 3 (spec: 12–16 ohms). on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).
Check for 12V on power wire and verify ground pulsing using a noid light while cranking. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).
Depressurize fuel system, lift rail, swap injector, lube new O-rings, and reinstall rail. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).
Clear DTC memory and monitor misfire counters on live data. on the Honda Pilot equipped with 3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto).
Equipment for Diagnosing Honda Pilot (P0202)
Honda Pilot OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Honda Pilot.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Honda Pilot
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Honda Pilot:
4. Honda Pilot P0202 FAQs
What causes code P0202 to trigger on a Honda Pilot?
On the Honda Pilot (3.5L DOHC 24-Valve V6 (285HP / 10-Speed Auto)), P0202 is most frequently caused by Cylinder 2 fuel injector internal coil failure or Broken wiring or corroded connector pin on Cylinder 2 harness.
Where is the OBD-II port located on my Honda Pilot?
On the Honda Pilot, the 16-pin DLC diagnostic connector is located Under driver steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Honda Pilot with code P0202?
No. Cylinder 2 is completely disabled by an electrical circuit fault, causing hard misfires. Given that P0202 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.