P0352 on Jeep Cherokee
Factory diagnostic protocol and troubleshooting wire for fault code P0352 specifically for the Jeep Cherokee (2020–2026, 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6).
1. Symptoms of P0352 on Jeep Cherokee
When the Engine Control Module (ECM/PCM) on your Jeep Cherokee (2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6) logs fault code P0352, drivers commonly observe:
2. Most Likely Causes on Jeep Cherokee
Historical warranty claims and technical repair bulletins for Jeep Cherokee point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Cherokee
Swap Coil 2 with Coil 1. If code becomes P0351, replace coil. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Verify 12V power and trigger pulse. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Replace Coil B with OEM part. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Clear DTCs and confirm zero misfires. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Equipment for Diagnosing Jeep Cherokee (P0352)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Jeep Cherokee.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Cherokee
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Cherokee:
4. Jeep Cherokee P0352 FAQs
What causes code P0352 to trigger on a Jeep Cherokee?
On the Jeep Cherokee (2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6), P0352 is most frequently caused by Dead Cylinder 2 ignition coil or Damaged harness wiring.
Where is the OBD-II port located on my Jeep Cherokee?
On the Jeep Cherokee, the 16-pin DLC diagnostic connector is located Under driver side lower dash trim panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Cherokee with code P0352?
No. Cylinder 2 ignition coil has failed. Given that P0352 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.