P0352 on Jeep Gladiator
Factory diagnostic protocol and troubleshooting wire for fault code P0352 specifically for the Jeep Gladiator (2020–2026, 3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave).
1. Symptoms of P0352 on Jeep Gladiator
When the Engine Control Module (ECM/PCM) on your Jeep Gladiator (3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave) logs fault code P0352, drivers commonly observe:
2. Most Likely Causes on Jeep Gladiator
Historical warranty claims and technical repair bulletins for Jeep Gladiator point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Gladiator
Swap Coil 2 with Coil 1. If code becomes P0351, replace coil. on the Jeep Gladiator equipped with 3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave.
Verify 12V power and trigger pulse. on the Jeep Gladiator equipped with 3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave.
Replace Coil B with OEM part. on the Jeep Gladiator equipped with 3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave.
Clear DTCs and confirm zero misfires. on the Jeep Gladiator equipped with 3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave.
Equipment for Diagnosing Jeep Gladiator (P0352)
Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)
Pre-gapped iridium spark plugs engineered to restore smooth combustion on Jeep Gladiator.
Magnetic Swivel Spark Plug Socket Set
360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Gladiator
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Gladiator:
4. Jeep Gladiator P0352 FAQs
What causes code P0352 to trigger on a Jeep Gladiator?
On the Jeep Gladiator (3.6L Pentastar V6 (285HP) / 3.0L EcoDiesel V6 (260HP 442 lb-ft) / Mojave), P0352 is most frequently caused by Dead Cylinder 2 ignition coil or Damaged harness wiring.
Where is the OBD-II port located on my Jeep Gladiator?
On the Jeep Gladiator, the 16-pin DLC diagnostic connector is located Under driver dash near left knee kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Gladiator with code P0352?
No. Cylinder 2 ignition coil has failed. Given that P0352 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.