U0104 on Jeep Cherokee
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Jeep Cherokee (2020–2026, 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6).
1. Symptoms of U0104 on Jeep Cherokee
When the Engine Control Module (ECM/PCM) on your Jeep Cherokee (2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Jeep Cherokee
Historical warranty claims and technical repair bulletins for Jeep Cherokee point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Cherokee
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Verify power feed to radar sensor. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Execute optical/radar alignment procedure if bumper was removed. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Clear DTCs and test cruise on highway. on the Jeep Cherokee equipped with 2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6.
Equipment for Diagnosing Jeep Cherokee (U0104)
Jeep Cherokee OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Jeep Cherokee.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Cherokee
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Cherokee:
4. Jeep Cherokee U0104 FAQs
What causes code U0104 to trigger on a Jeep Cherokee?
On the Jeep Cherokee (2.4L Tigershark MultiAir / 2.0L Turbo (270HP) / 3.2L Pentastar V6), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Jeep Cherokee?
On the Jeep Cherokee, the 16-pin DLC diagnostic connector is located Under driver side lower dash trim panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Cherokee with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.