P0137 on Jeep Compass
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Jeep Compass (2021–2026, 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP)).
1. Symptoms of P0137 on Jeep Compass
When the Engine Control Module (ECM/PCM) on your Jeep Compass (2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP)) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on Jeep Compass
Historical warranty claims and technical repair bulletins for Jeep Compass point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Jeep Compass
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Jeep Compass equipped with 2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP).
Equipment for Diagnosing Jeep Compass (P0137)
Jeep Compass OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Jeep Compass.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Jeep Compass
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Jeep Compass:
4. Jeep Compass P0137 FAQs
What causes code P0137 to trigger on a Jeep Compass?
On the Jeep Compass (2.0L MultiAir Turbo 4-Cyl (177HP) / 1.3L Turbo 4xe PHEV (240HP)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my Jeep Compass?
On the Jeep Compass, the 16-pin DLC diagnostic connector is located Driver lower dash near hood lever assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Jeep Compass with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.