P0137 on Lexus ES
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Lexus ES (2020–2026, 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD).
1. Symptoms of P0137 on Lexus ES
When the Engine Control Module (ECM/PCM) on your Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on Lexus ES
Historical warranty claims and technical repair bulletins for Lexus ES point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Lexus ES
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Equipment for Diagnosing Lexus ES (P0137)
Lexus ES OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Lexus ES.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Lexus ES
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Lexus ES:
4. Lexus ES P0137 FAQs
What causes code P0137 to trigger on a Lexus ES?
On the Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my Lexus ES?
On the Lexus ES, the 16-pin DLC diagnostic connector is located Directly under driver dash, left side of steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Lexus ES with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.