U0104 on Mazda CX-90
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Mazda CX-90 (2024–2026, 3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV).
1. Symptoms of U0104 on Mazda CX-90
When the Engine Control Module (ECM/PCM) on your Mazda CX-90 (3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Mazda CX-90
Historical warranty claims and technical repair bulletins for Mazda CX-90 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Mazda CX-90
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Mazda CX-90 equipped with 3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV.
Verify power feed to radar sensor. on the Mazda CX-90 equipped with 3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV.
Execute optical/radar alignment procedure if bumper was removed. on the Mazda CX-90 equipped with 3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV.
Clear DTCs and test cruise on highway. on the Mazda CX-90 equipped with 3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV.
Equipment for Diagnosing Mazda CX-90 (U0104)
Mazda CX-90 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Mazda CX-90.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Mazda CX-90
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Mazda CX-90:
4. Mazda CX-90 U0104 FAQs
What causes code U0104 to trigger on a Mazda CX-90?
On the Mazda CX-90 (3.3L Turbo I6 (340HP) / PHEV Turbo 6 (323HP) / e-Skyactiv PHEV), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Mazda CX-90?
On the Mazda CX-90, the 16-pin DLC diagnostic connector is located Under driver lower dash trim above pedal cluster. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Mazda CX-90 with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.