U0104 on Nissan Frontier
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Nissan Frontier (2020–2026, 3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto)).
1. Symptoms of U0104 on Nissan Frontier
When the Engine Control Module (ECM/PCM) on your Nissan Frontier (3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto)) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Nissan Frontier
Historical warranty claims and technical repair bulletins for Nissan Frontier point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Nissan Frontier
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Nissan Frontier equipped with 3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto).
Verify power feed to radar sensor. on the Nissan Frontier equipped with 3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto).
Execute optical/radar alignment procedure if bumper was removed. on the Nissan Frontier equipped with 3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto).
Clear DTCs and test cruise on highway. on the Nissan Frontier equipped with 3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto).
Equipment for Diagnosing Nissan Frontier (U0104)
Nissan Frontier OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Nissan Frontier.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Nissan Frontier
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Nissan Frontier:
4. Nissan Frontier U0104 FAQs
What causes code U0104 to trigger on a Nissan Frontier?
On the Nissan Frontier (3.8L DOHC V6 (310HP / 281 lb-ft / 9-Speed Auto)), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Nissan Frontier?
On the Nissan Frontier, the 16-pin DLC diagnostic connector is located Under driver dash above brake assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Nissan Frontier with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.