MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.
P0351RAMRAM 1500 TRX HubAll RAM P0351Critical Severity

P0351 on RAM 1500 TRX

Ignition Coil A Primary/Secondary Circuit Malfunction

Factory diagnostic protocol and troubleshooting wire for fault code P0351 specifically for the RAM 1500 TRX (2021–2024, 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)).

Verified OEM Telemetry & Field Repair Tree
RAM 1500 TRX2021–2024
RAM 1500 TRX
Truck6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
1500 TRX SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Not Recommended
Critical urgency level
Est. Repair Cost
$100 - $350 (DIY: $30 - $90)
Parts & Labor DIY
Check P0351 On Another RAM Model:
Diagnose P0351 on Specific 1500 TRX Model Year:

1. Symptoms of P0351 on RAM 1500 TRX

When the Engine Control Module (ECM/PCM) on your RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)) logs fault code P0351, drivers commonly observe:

Flashing Check Engine Light on RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2))
Severe engine shuddering and jerking under acceleration on RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2))
Hard misfire on Cylinder 1 (accompanied by P0301) on RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2))
Strong smell of unburned gasoline from exhaust on RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2))
RAM 1500 TRX OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash assembly next to hood release lever. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on RAM 1500 TRX

Historical warranty claims and technical repair bulletins for RAM 1500 TRX point to the following failure distribution:

55%
Failed ignition coil pack on Cylinder 1 (Coil A) (RAM OEM Part)
25%
Broken or melted wiring harness to ignition coil 1 (RAM OEM Part)
12%
Corroded or broken terminal pins in coil electrical connector (RAM OEM Part)
8%
Burned ignition driver transistor (IGBT) inside the ECM/PCM (RAM OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for RAM 1500 TRX.

3. Step-by-Step DIY Repair Guide for RAM 1500 TRX

01
Locate Coil A (Cylinder 1 Ignition Coil)

Identify Cylinder 1 ignition coil pack mounted on the valve cover. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).

Required Tool: Flashlight
02
Perform Coil Swap Test

Swap Coil 1 with Coil 2. Clear codes and restart engine. If code switches to P0352 (Coil B), the ignition coil is 100% defective. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).

Required Tool: 10mm Socket, Ratchet, OBD-II Scanner
03
Test Wiring Harness if Code Remains P0351

Check for 12V battery power, chassis ground, and 5V trigger pulse from the PCM on the 3-pin / 4-pin harness plug. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).

Required Tool: Digital Multimeter, Test Light
04
Replace Ignition Coil & Spark Plug

Install a new OEM ignition coil (e.g. Denso, Motorcraft, Delphi) and replace the spark plug on Cylinder 1. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).

Required Tool: 5/8 Spark Plug Socket, 10mm Socket, Ratchet
05
Clear Trouble Codes and Road Test

Clear DTCs and verify smooth acceleration under load. on the RAM 1500 TRX equipped with 6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2).

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing RAM 1500 TRX (P0351)

Prime Fast Delivery & Verified Fitment
OEM Ignition Component

Direct-Fit Laser Iridium Spark Plugs (Set of 4/6)

4.8 / 5.0 (Top Rated)

Pre-gapped iridium spark plugs engineered to restore smooth combustion on RAM 1500 TRX.

$36 – $68 Prime
Check Price on Amazon
Ignition Service Tool

Magnetic Swivel Spark Plug Socket Set

4.8 / 5.0 (Amazon Choice)

360-degree magnetic swivel socket prevents ceramic plug cracks inside deep engine spark wells.

$16.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for RAM 1500 TRXVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on RAM 1500 TRX

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the RAM 1500 TRX:

4. RAM 1500 TRX P0351 FAQs

What causes code P0351 to trigger on a RAM 1500 TRX?

On the RAM 1500 TRX (6.2L Supercharged HEMI V8 (702HP / 650 lb-ft / Bilstein Black Hawk e2)), P0351 is most frequently caused by Failed ignition coil pack on Cylinder 1 (Coil A) or Broken or melted wiring harness to ignition coil 1.

Where is the OBD-II port located on my RAM 1500 TRX?

On the RAM 1500 TRX, the 16-pin DLC diagnostic connector is located Driver lower dash assembly next to hood release lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my RAM 1500 TRX with code P0351?

No. Cylinder 1 ignition coil has failed completely, causing an active misfire and dumping unburned fuel into the catalytic converter. Given that P0351 carries a Critical severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.