P0137 on Toyota Highlander
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Toyota Highlander (2020–2026, 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid).
1. Symptoms of P0137 on Toyota Highlander
When the Engine Control Module (ECM/PCM) on your Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on Toyota Highlander
Historical warranty claims and technical repair bulletins for Toyota Highlander point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Highlander
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Toyota Highlander equipped with 2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid.
Equipment for Diagnosing Toyota Highlander (P0137)
Toyota Highlander OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Toyota Highlander.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Toyota Highlander
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Highlander:
4. Toyota Highlander P0137 FAQs
What causes code P0137 to trigger on a Toyota Highlander?
On the Toyota Highlander (2.4L Turbo 4-Cyl (T24A-FTS 265HP) / 3.5L V6 / 2.5L Hybrid), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my Toyota Highlander?
On the Toyota Highlander, the 16-pin DLC diagnostic connector is located Under driver steering column near kick panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Highlander with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.