P0137 on Toyota Prius
Factory diagnostic protocol and troubleshooting wire for fault code P0137 specifically for the Toyota Prius (2020–2026, 2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP)).
1. Symptoms of P0137 on Toyota Prius
When the Engine Control Module (ECM/PCM) on your Toyota Prius (2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP)) logs fault code P0137, drivers commonly observe:
2. Most Likely Causes on Toyota Prius
Historical warranty claims and technical repair bulletins for Toyota Prius point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Prius
Listen for exhaust ticking or black soot around flex pipe, flanges, and sensor bungs before the catalytic converter. on the Toyota Prius equipped with 2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP).
Monitor B1S2 voltage. Snap the throttle to enrich mixture; voltage should briefly spike above 0.8V. If it remains 0.0V–0.1V, sensor is defective or shorted. on the Toyota Prius equipped with 2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP).
Unplug harness, remove old sensor with 7/8 socket, install replacement sensor and plug firmly. on the Toyota Prius equipped with 2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP).
Clear DTCs and verify B1S2 holds steady between 0.45V and 0.75V during steady highway cruising. on the Toyota Prius equipped with 2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP).
Equipment for Diagnosing Toyota Prius (P0137)
Toyota Prius OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Toyota Prius.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Toyota Prius
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Prius:
4. Toyota Prius P0137 FAQs
What causes code P0137 to trigger on a Toyota Prius?
On the Toyota Prius (2.0L 4-Cyl Hybrid (M20A-FXS 196HP) / Prius Prime PHEV (220HP)), P0137 is most frequently caused by Exhaust leak upstream of or directly at the Sensor 2 bung letting in fresh air or Faulty downstream oxygen sensor.
Where is the OBD-II port located on my Toyota Prius?
On the Toyota Prius, the 16-pin DLC diagnostic connector is located Under driver side dashboard near A-pillar trim. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Prius with code P0137?
Yes. Vehicle is fully drivable, but Check Engine Light will remain illuminated. Given that P0137 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.