U0104 on Audi A6
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Audi A6 (2020–2026, 3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro).
1. Symptoms of U0104 on Audi A6
When the Engine Control Module (ECM/PCM) on your Audi A6 (3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Audi A6
Historical warranty claims and technical repair bulletins for Audi A6 point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Audi A6
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Audi A6 equipped with 3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro.
Verify power feed to radar sensor. on the Audi A6 equipped with 3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro.
Execute optical/radar alignment procedure if bumper was removed. on the Audi A6 equipped with 3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro.
Clear DTCs and test cruise on highway. on the Audi A6 equipped with 3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro.
Equipment for Diagnosing Audi A6 (U0104)
Audi A6 OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Audi A6.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Audi A6
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Audi A6:
4. Audi A6 U0104 FAQs
What causes code U0104 to trigger on a Audi A6?
On the Audi A6 (3.0L Turbo V6 (A7/A8 S6 450HP) / 2.0L TFSI 261HP / 55 TFSI quattro), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Audi A6?
On the Audi A6, the 16-pin DLC diagnostic connector is located Driver lower dash trim near parking brake assembly. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Audi A6 with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.