U0104 on BMW 5 Series
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the BMW 5 Series (2020–2026, 2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV).
1. Symptoms of U0104 on BMW 5 Series
When the Engine Control Module (ECM/PCM) on your BMW 5 Series (2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on BMW 5 Series
Historical warranty claims and technical repair bulletins for BMW 5 Series point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for BMW 5 Series
Clean snow, ice, mud, or dead bugs off front radar emblem. on the BMW 5 Series equipped with 2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV.
Verify power feed to radar sensor. on the BMW 5 Series equipped with 2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV.
Execute optical/radar alignment procedure if bumper was removed. on the BMW 5 Series equipped with 2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV.
Clear DTCs and test cruise on highway. on the BMW 5 Series equipped with 2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV.
Equipment for Diagnosing BMW 5 Series (U0104)
BMW 5 Series OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for BMW 5 Series.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on BMW 5 Series
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the BMW 5 Series:
4. BMW 5 Series U0104 FAQs
What causes code U0104 to trigger on a BMW 5 Series?
On the BMW 5 Series (2.0L Turbo (B48) / 3.0L Turbo I6 (B58) / 4.4L Twin-Turbo V8 (N63) / i5 EV), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my BMW 5 Series?
On the BMW 5 Series, the 16-pin DLC diagnostic connector is located Driver lower kick panel near hood release lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my BMW 5 Series with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.