U0104 on Lexus ES
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Lexus ES (2020–2026, 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD).
1. Symptoms of U0104 on Lexus ES
When the Engine Control Module (ECM/PCM) on your Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Lexus ES
Historical warranty claims and technical repair bulletins for Lexus ES point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Lexus ES
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Verify power feed to radar sensor. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Execute optical/radar alignment procedure if bumper was removed. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Clear DTCs and test cruise on highway. on the Lexus ES equipped with 3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD.
Equipment for Diagnosing Lexus ES (U0104)
Lexus ES OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Lexus ES.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Lexus ES
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Lexus ES:
4. Lexus ES U0104 FAQs
What causes code U0104 to trigger on a Lexus ES?
On the Lexus ES (3.5L V6 (2GR-FKS 302HP) / 2.5L Hybrid (ES 300h 215HP) / 2.5L AWD), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Lexus ES?
On the Lexus ES, the 16-pin DLC diagnostic connector is located Directly under driver dash, left side of steering column. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Lexus ES with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.