P0135 on Toyota Camry TRD: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically on the Toyota Camry TRD (2020–2025, 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust)).
1. Symptoms of P0135 on Toyota Camry TRD
When the Engine Control Module (ECM/PCM) on your Toyota Camry TRD (3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust)) logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Toyota Camry TRD
Historical warranty claims and technical repair bulletins for Toyota Camry TRD point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Camry TRD
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on the Toyota Camry TRD equipped with 3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust).
Other Common Fault Codes on Toyota Camry TRD
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Camry TRD:
4. Toyota Camry TRD P0135 FAQs
What causes code P0135 to trigger on a Toyota Camry TRD?
On the Toyota Camry TRD (3.5L V6 DOHC 24V with Dual VVT-i (301 HP / TRD Cat-Back Exhaust)), P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse.
Where is the OBD-II port located on my Toyota Camry TRD?
On the Toyota Camry TRD, the 16-pin DLC diagnostic connector is located Driver footwell lower knee bolster panel. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Camry TRD with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.