P0135 on Toyota Crown: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically on the Toyota Crown (2023–2026, 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD).
1. Symptoms of P0135 on Toyota Crown
When the Engine Control Module (ECM/PCM) on your Toyota Crown (2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD) logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Toyota Crown
Historical warranty claims and technical repair bulletins for Toyota Crown point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Crown
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on the Toyota Crown equipped with 2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD.
Other Common Fault Codes on Toyota Crown
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Crown:
4. Toyota Crown P0135 FAQs
What causes code P0135 to trigger on a Toyota Crown?
On the Toyota Crown (2.4L Turbo Hybrid MAX (340HP) / 2.5L THS II Hybrid AWD), P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse.
Where is the OBD-II port located on my Toyota Crown?
On the Toyota Crown, the 16-pin DLC diagnostic connector is located Driver lower footwell beneath OBD protective lip. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Crown with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.