P0135 on Toyota Camry: Fix & DLC Location
Factory diagnostic troubleshooting wire for fault code P0135 (O2 Sensor Heater Circuit Malfunction (Bank 1, Sensor 1)) specifically on the Toyota Camry (2020–2026, 2.5L 4-Cyl (A25A-FKS) / 3.5L V6 (2GR-FKS) 301HP).
1. Symptoms of P0135 on Toyota Camry
When the Engine Control Module (ECM/PCM) on your Toyota Camry (2.5L 4-Cyl (A25A-FKS) / 3.5L V6 (2GR-FKS) 301HP) logs fault code P0135, drivers commonly observe:
2. Most Likely Causes on Toyota Camry
Historical warranty claims and technical repair bulletins for Toyota Camry point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota Camry
Locate the under-hood fuse box and test the O2 sensor heater fuse with a multimeter or test light. on the Toyota Camry equipped with 2.5L 4-Cyl (A25A-FKS) / 3.5L V6 (2GR-FKS) 301HP.
Unplug the Bank 1 Sensor 1 connector and test resistance between the two heater pins (typically 3 to 15 ohms). on the Toyota Camry equipped with 2.5L 4-Cyl (A25A-FKS) / 3.5L V6 (2GR-FKS) 301HP.
Use an O2 sensor socket wrench to remove the old sensor from the exhaust manifold and install an OEM-spec replacement with anti-seize on the threads. on the Toyota Camry equipped with 2.5L 4-Cyl (A25A-FKS) / 3.5L V6 (2GR-FKS) 301HP.
Other Common Fault Codes on Toyota Camry
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota Camry:
4. Toyota Camry P0135 FAQs
What causes code P0135 to trigger on a Toyota Camry?
On the Toyota Camry (2.5L 4-Cyl (A25A-FKS) / 3.5L V6 (2GR-FKS) 301HP), P0135 is most frequently caused by Burnt-out internal heating element in upstream oxygen sensor or Blown O2 sensor heater fuse.
Where is the OBD-II port located on my Toyota Camry?
On the Toyota Camry, the 16-pin DLC diagnostic connector is located Directly under driver dash, left of steering column above brake pedal. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota Camry with code P0135?
Yes, vehicle is safe to drive, but will stay in open-loop mode longer upon startup. Given that P0135 carries a Low to Medium severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.