MazicBay Diagnostics
MAZICBAYDiagnostics
FTC Reader Disclosure: When you purchase or register through links on our site, we may earn an affiliate commission at no extra cost to you. Read our Editorial & Advertising Policy.

P0457 on Dodge Charger

EVAP System Leak Detected (Fuel Cap Loose/Off)

Factory diagnostic protocol and troubleshooting wire for fault code P0457 specifically for the Dodge Charger (2020–2026, 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo).

Verified OEM Telemetry & Field Repair Tree
Dodge Charger2020–2026
Dodge Charger
Sedan5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo
Reliability
Sensor Voltage Ref
0.1V – 5.0V Ref
Charger SAE Mode $01
ECU Network Bus
500 kbps CAN-FD
ISO 15765-4 Compliant
Drivability Status
Drivable (Short Trip)
Low urgency level
Est. Repair Cost
$0 - $120 (DIY: $0 - $30)
Parts & Labor DIY
Check P0457 On Another Dodge Model:
Diagnose P0457 on Specific Charger Model Year:

1. Symptoms of P0457 on Dodge Charger

When the Engine Control Module (ECM/PCM) on your Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo) logs fault code P0457, drivers commonly observe:

'CHECK FUEL CAP' message in dash display on Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo)
Illuminated Check Engine Light on Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo)
Slight gasoline vapor odor near fuel door on Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo)
Dodge Charger OBD-II Port Location
The 16-pin diagnostic connector is located Driver lower dash assembly next to hood lever. Plug in your scan tool to verify freeze-frame sensor values.

2. Most Likely Causes on Dodge Charger

Historical warranty claims and technical repair bulletins for Dodge Charger point to the following failure distribution:

55%
Loose, unclicked, or forgotten gas cap (Dodge OEM Part)
25%
Cracked, dried out, or missing rubber O-ring gasket on fuel cap (Dodge OEM Part)
12%
Cracked filler neck neck where gas cap seals (Dodge OEM Part)
8%
Faulty EVAP fuel tank pressure sensor (FTP) (Dodge OEM Part)
* Source: Synthesized from NHTSA ODI field repair telemetry and verified OEM Technical Service Bulletin (TSB) repair tree frequency percentiles for Dodge Charger.

3. Step-by-Step DIY Repair Guide for Dodge Charger

01
Inspect and Tighten Gas Cap

Unscrew gas cap, inspect rubber seal for cracks, reinstall and turn until it clicks firmly 3 times. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

Required Tool: None
02
Inspect Fuel Filler Neck Lip

Check the metal filler neck lip for rust, grit, or dings preventing a tight seal. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

Required Tool: Clean Rag
03
Replace Gas Cap with OEM Replacement

If rubber gasket is flattened or hardened, buy a factory OEM gas cap. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

Required Tool: OEM Gas Cap
04
Clear Trouble Code or Drive

Clear DTCs with scanner, or drive vehicle for 3–5 days until the PCM runs an overnight EVAP vacuum decay test and turns off the light automatically. on the Dodge Charger equipped with 5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo.

Required Tool: OBD-II Scanner
Recommended Parts & Testing Tools

Equipment for Diagnosing Dodge Charger (P0457)

Prime Fast Delivery & Verified Fitment
EVAP Seal Replacement

OEM Tethered Fuel Gas Cap with O-Ring

4.7 / 5.0 (Direct Fit)

Tight-sealing factory fuel cap resolves common EVAP small/large leak codes without workshop visits.

$17 – $26 Prime
Check Fitment on Amazon
Sensor Signal Voltage Meter

AstroAI Auto-Ranging Digital Multimeter

4.6 / 5.0 (Best Seller)

Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.

$29.99 Prime
View on Amazon
Top Mobile OBD-II Scanner

BlueDriver Bluetooth Pro OBDII Scan Tool

4.7 / 5.0 (50,000+ Reviews)

Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.

Compare OEM & Aftermarket Replacement Sensors for Dodge ChargerVerified direct-fit pricing from Denso, Bosch, Motorcraft, and ACDelco on Amazon.
Find Parts on Amazon
* As an Amazon Associate, MazicBay earns from qualifying purchases. Prices & availability subject to change.

Other Common Fault Codes on Dodge Charger

Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Dodge Charger:

4. Dodge Charger P0457 FAQs

What causes code P0457 to trigger on a Dodge Charger?

On the Dodge Charger (5.7L / 6.4L 392 HEMI / 6.2L Hellcat (717HP–797HP) / Hurricane 3.0L Turbo), P0457 is most frequently caused by Loose, unclicked, or forgotten gas cap or Cracked, dried out, or missing rubber O-ring gasket on fuel cap.

Where is the OBD-II port located on my Dodge Charger?

On the Dodge Charger, the 16-pin DLC diagnostic connector is located Driver lower dash assembly next to hood lever. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.

Can I safely drive my Dodge Charger with code P0457?

Yes. Safe to drive indefinitely, but fuel vapors escape into the atmosphere. Given that P0457 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.