U0104 on Toyota 4Runner
Factory diagnostic protocol and troubleshooting wire for fault code U0104 specifically for the Toyota 4Runner (2020–2026, 4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl).
1. Symptoms of U0104 on Toyota 4Runner
When the Engine Control Module (ECM/PCM) on your Toyota 4Runner (4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl) logs fault code U0104, drivers commonly observe:
2. Most Likely Causes on Toyota 4Runner
Historical warranty claims and technical repair bulletins for Toyota 4Runner point to the following failure distribution:
3. Step-by-Step DIY Repair Guide for Toyota 4Runner
Clean snow, ice, mud, or dead bugs off front radar emblem. on the Toyota 4Runner equipped with 4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl.
Verify power feed to radar sensor. on the Toyota 4Runner equipped with 4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl.
Execute optical/radar alignment procedure if bumper was removed. on the Toyota 4Runner equipped with 4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl.
Clear DTCs and test cruise on highway. on the Toyota 4Runner equipped with 4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl.
Equipment for Diagnosing Toyota 4Runner (U0104)
Toyota 4Runner OEM Replacement Sensor
Direct-fit replacement assembly engineered to OEM tolerances for Toyota 4Runner.
AstroAI Auto-Ranging Digital Multimeter
Essential for testing 0.1V–5.0V sensor reference signals, ground continuity (<0.20Ω), and harness resistance.
BlueDriver Bluetooth Pro OBDII Scan Tool
Reads and clears enhanced codes (ABS, Airbag, Transmission, Engine) & live freeze-frame telemetry on phone.
Other Common Fault Codes on Toyota 4Runner
Frequently diagnosed powertrain, emissions, and sensor trouble codes logged on the Toyota 4Runner:
4. Toyota 4Runner U0104 FAQs
What causes code U0104 to trigger on a Toyota 4Runner?
On the Toyota 4Runner (4.0L V6 (1GR-FE) / 2.4L i-FORCE Turbo 4-Cyl), U0104 is most frequently caused by Blocked or dirty front radar sensor in grille/bumper or Blown radar module fuse.
Where is the OBD-II port located on my Toyota 4Runner?
On the Toyota 4Runner, the 16-pin DLC diagnostic connector is located Lower dashboard near parking brake mechanism. Plug in any standard OBD-II scanner with the ignition in the ON position to read freeze-frame parameters.
Can I safely drive my Toyota 4Runner with code U0104?
Yes. Normal driving is unaffected, but Adaptive Cruise Control will not engage. Given that U0104 carries a Low severity rating, we advise avoiding heavy towing or aggressive throttle inputs until sensor readings are verified.